UMD V3 Installation Manual - Remote Control
13 November 2018
Page
23
of
39
Mounting Centers
(2 by 3.5mm by 13mm slot holes in
base flanges)
Mountable in any attitude
subject to antenna requirements
Environmental Specifications
Sealing
Wet assembled
Operational Temperature
-30
C to +70
C (external)
Compliance and Safety
FCC Compliance:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Modifications not expressly approved by the manufacturer could void the user's authority to operated the equipment under
FCC rules.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INTRUCTIONS.
Function of Cellular Component
The UMD reports to the server approximately once every 15 minutes on the LTE or 3G mobile carrier
networks, transferring close to 100 kB of data per day.
In the US and Canada, model
WG-V3-LTE-NA
, the UMD uses a ublox TOBY-R202, communicating on LTE bands
2, 4, 5 and 12, as well as UMTS bands 850 and 1900.
In the APAC region, including Australia and New Zealand, model
WG-V3-LTE-AP
, the UMD uses ublox TOBY-
L280, operating in LTE bands 1, 3, 5, 7, 8, and 28, as well as UMTS hands 850/900 and 1900/2100.
