UMD V3 Installation Manual - Remote Control
13 November 2018
Page
6
of
39
5)
All installations must be fully validated by Cooltrax Support before the asset leaves the installation
location. Cooltrax will not be liable for costs incurred through the asset being recalled for validation at
a later time.
6)
No Cooltrax Hardware or component is to be replaced without consultation and agreement from a
Cooltrax support staff member.
7)
Hardware must not be opened outside of the Cooltrax Office.
Considerations When Installing or Servicing a Cooltrax Unit:
Temperature Increases Within the Trailer :
The Reefer unit MUST be turned off when installing or conducting maintenance on A Cooltrax
Unit, this will lead to increased temperatures within the trailer and if the trailer is loaded the
goods may be damaged. Always give due consideration to the temperature within the trailer,
Cooltrax will not be held responsible for any spoiled contents.
Warning Risk of Electrical Shock:
Always remove the battery cable from the negative terminal followed by the cable from the
positive terminal prior to commencing an installation or service of Cooltrax hardware. There is
danger of exposure to high electrical energy during installation procedures highlighted in this
manual and a risk of shock or injury. Only trained Technical staff should install service or
maintain Cooltrax hardware.
DANGER: Risk of Personal Injury
.
This unit can be remote controlled. The unit may START and STOP at any time by remote
command. Prior to performing any maintenance to the unit, place the Maintenance Toggle
Switch (located on the Cooltrax Maintenance Box) to the MAINT MODE position to disable the
remote starting capability.
Picture 2: UMD Connections.
