P44
P45
CLEANING
1, in order to keep the car clean and protect the surface
appearance of the painting, electroplating, should regularly
or irregularly its cleansing. When cleaning, use of external
surface water irrigation, rush soil. Use a soft cloth or sponge
dip cleaning liquid bubble gently cleans the outer surface, to
avoid residual gravel surface and paint scratches
electroplating layer. Finally reuse water for irrigation.
2, attention:
● washing, to avoid using the high-pressure water erosion
under parts:
(1) ignition switch;
(2) multi-purpose switch;
(3) Below cushion;
(4) The exhaust pipe muffler exports;
(5) air filter inlet
After the car wash thoroughly dry, and then start engine,
running for a few minutes. Finally repeatedly braking
performance brake inspection and adjustment until braking
performance standards so far.
Special Note: in the hot engine, the first will not wash.
Engine room temperature with the same question again
when cleaning. If water pressure caused the brake, the
former damping seals and electrical parts Loss
STORAGE
If the park does not need to use a long time, in order to
maintain a good state of the car, you please address the
following methods:
1), select the right parking place. The location should have
security,
ventilation,
moisture-proof,
anti-freezing
conditions.
2), for engine lubricants.
3) in the fuel tank and the carburetor fuel release all net,
oil stored properly. Note: Do not overlook the release
carburetor net residual oil. Otherwise, no need for a long
time, the surface of the plastic fuel carburetor of holes to
plug, re-use of the car when trouble.
Warning: volatile fuel in the fuel emissions, the engine
must be stopped operating in the ventilation good place to
prohibit smoking ban on the use of open flame and sparks
objects.
4) In order to prevent cylinder rust, we should adopt the
following measures:
Remove spark plugs, A Spoonful (15 ~ 20 m) from the clean
engine oil into the cylinder spark plug hole with a piece of
cloth spark plug holes starter motors, mobile number to
Detroit from top to bottom so that the oil in the cylinder wall
are cloth. Finally, the spark plugs and spark plug cap
installed.
5) Battery demolition down, stored in antifreeze,
sunscreen, and other items collision difficult places. Every
two weeks an additional charge.
6) wash and dry your car, paint waxing to all, to all chrome
painted on the surface antirust oil.
