P28
P29
Parts / Fasteners
Prior to the use of the car, should always check with
the parts and fasteners tight degrees. We suggest that
these projects should be carried out irregular
inspections. (I asked, after the demolition of the
self-locking nut Please replacement of the self-locking
nut, as will the use of safety.)
Correspondence tables fastening torque
M5
4.5- 6.0
5
M10
37- 79
60
M6
8-12
9
M12
73- 115
99
M8
16-26
23
M14
146- 205
180
Screw
size
Fightening
torque
N•M
Standard
torque
N•M
Screw
size
Fightening
torque
N
•
M
Standard
torque
N
•
M
1, the measurement of oil (
See left picture
)
A. Engine preheater minutes.
B. When the engine stopped operating, hold on a few minutes
later, the oil Cypriots will be removed after the oil-observation.
C. The oil should be located at the highest and the lowest
among the oil-marker. If the oil level low, should be enough oil
to rise to the oil-appropriate.
2, oil and oil filter replacement of the replacement. (See right
picture
)
A. Engine preheater minutes.
B. engine will stop. In an engine oil was placed underneath.
C. discard release oil bolts, release oil. Put oil may moderate
shaking body to be inside the engine from impurities.
Oil
D. installed release oil bolts, and then full of engine oil.
Tightening oil Cypriots.
I. Starting engine and a few minutes to preheat. Preheat should
check whether there are oil spills. If it appears that an oil spill,
should immediately stop engine and check reasons.
3, the replacement of oil in the second about a month or so to
clean oil filters
Warning:
● Do not join any chemical additives. Also lubricating oil clutch,
clutch slipping and additives will.
