P30
P31
Note: In the replacement of oil, must be in accordance with the
following method to check oil pressure.
1, removed the cylinder covered with oil release bolts.
2, starter motors, and keep them idle until the oil outflow from
caving hole. If no one minute after the oil outflow or unusual
phenomenon, should stop the engine running to the nearest
COOLSTER dealer or repair shop for repair.
3, after the test should be tightened release oil bolts.
Carburetor adjustment
Carburetor is a key part of the car, the need for fine adjustment.
Most adjustments should be entrusted with the expertise and
experience COOLSTER dealers or repair shops.
Standard Idle:
1500 ± 150 to / min
1. Connect speed
2. Speed Festival through idle screw on the carburetor, idling
provisions set to rotate within the raise into the engine speed, to
a decrease in engine speed from
Idle adjustment
Release oil point
Screw ialing
Crankcase emission filter of the circulatory system
1
、
the part works for 150 hours, please cleaning to make
the part to use normaly.
2
、
take out filter of oil and gas separator, using gasoline or
kerosene to carry out the washing, and drying.
3
、
in the filter out, remember not to damage the filter.
4
、
the part may clean and use repeatedly in the
non-damage’s situation.
5
、
the partin use, will be regularly open sewage outfall for
discharge, the user can also be observed at any time, please
discharge the squalidity in accordance with the actual
situation.
