Apricus Installation Manual
42
Rear Legs
E
ach rear leg has two pieces, a top and a
bottom, which allows them to be adjusted.
The two pieces must always be joined
together by 2 bolts through two sets of
holes each in each leg for structural support.
Lower Angles
If an angle less than 27
o
is required the low
angle frame kit should be used which
provides an installation angle of 12
o
.
Higher Angles
If an angle greater than 57
o
is required, the
mounting points of the rear feet may be
raised. Raising the angle greatly increases
the horizontal force during high winds and
may require additional structural and/or
hardware upgrades. Consult a building
engineer for design requirements.
Standard Frame
Support Rail
Standard Frame
Side Rail
Diagonal Brace
Top Rear
Leg
Bottom Rear Leg
When fitting place the large metal washers
between the inner wall of the side rail and
the outer face of the diagonal brace to
ensure a tight fit
Adjust location of diagonal
brace to chosen angle
(from 27ƒ to 52ƒ )
Apricus A-Frame
Supplied with
Round Fixing Feet
as Standard
Optional Rubber Pad for
attaching to metal roofs
to eliminate galvanic
corrosion risks
