RS-232 and
Telnet Commands
Command
Description
A 1~A 4
Switch output A to 1~4
B 1~B 4
Switch output B to 1~4
IPCONFIG
Display the current IP config
IPDHCP
0=Set IP mode to static, 1=Set IP mode to DHCP
SIPADDR
Set Ethernet IP address
SNETMASK
Set Ethernet netmask
SGATEWAY
Set Ethernet gateway
HTTPPORT
Set http port number
RSTIP
IP configuration reset to factory defaults (DHCP)
IP mode: static, IP address: 192.168.1.50
Netmask: 255.255.255.0, Gateway: 192.168.1.1
Http port: 80, Telnet port: 23
P0
Power off
P1
Power on
ST
Displays the current matrix state and firmware
version
?
Display all available commands
REBOOT
Reboot the unit
FADEFAULT
Reset all settings to factory default
UPDATE
Firmware update
Note:
Any commands will be not executed unless followed with a carriage
return. All commands are case-sensitive
Telnet Control
Before attempting to use the Telnet control, please ensure that both the Matrix (via the
'LAN /CONTROL' port) and the PC/Laptop are connected to the same active networks.
To access the telnet control in Windows 7, click on ‘Start’ menu and type “cmd” in the
Search field then press enter.
Under Windows XP go to the ‘Start’ menu and click on “Run”, type “cmd” and press
enter.
Under Mac OS X, go to Go→Application→Utilities→Terminal
