Danfoss FCM 300 PROFIBUS, Manual

Page: 1 / 39

FCM 300 PROFIBUS / VLT 2800 PROFIBUS
MG.90.A2.02 – VLT is a registered Danfoss trademark 1
Contents
■
Introduction .............................................................. 3
■
Quick Setup .............................................................. 4
■
The PROFIBUS interface .......................................... 5
■
FCM 300 FCM 300 FCM 300 FCM 300 FCM 300 - Physical connection ............................... 7
■
VL VL VL VL VLT 2800 T 2800 T 2800 T 2800 T 2800 - Physical connection ............................. 10
■
System layout ......................................................... 13
■
Timing .................................................................... 15
■
DP (Distributed Periphery) ....................................... 16
■
Parameters ............................................................. 30
■
Warning and alarm messages ................................ 35
■
Glossary and parameter list .................................... 36
■
Index ...................................................................... 39
Copyrights, Limitation of Liability and Revision Rights.
This publication contains information proprietary to Danfoss A/S. By accepting and using this manual the user
agrees that the information contained herein will be used solely for operating equipment of Danfoss A/S or
equipment from other vendors provided that such equipment is intended for communication with Danfoss
equipment over a PROFIBUS serial communication link. This publication is protected under the Copyright laws of
Denmark and most other countries.
Danfoss A/S does not warrant that a software program produced according to the guidelines provided in this
manual will function properly in every physical, hardware or software environment.
Although Danfoss A/S has tested and reviewed the documentation within this manual, Danfoss A/S makes no
warranty or representation, either express or implied, with respect to this documentation, including its quality,
performance, or fitness for a particular purpose.
In no event shall Danfoss A/S be liable for direct, indirect, special, incidental, or consequential damages arising
out of the use, or the inability to use information contained in this manual, even if advised of the possibility of such
damages. In particular, Danfoss A/S is not responsible for any costs including but not limited to those incurred as
a result of lost profits or revenue, loss or damage of equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
Danfoss A/S reserves the right to revise this publication at any time and to make changes in its contents without
prior notice or any obligation to notify previous users of such revisions or changes.