3.
6.
b) Individual or zone heating confi guration.
Zone heating confi guration:
One cassette programmer can operate several hea-
ters using the pilot wire. Connect the pilot wire of the
heater fi tted with the Programmer module (master) to
the pilot wire of the other heaters (slaves) as shown
on the picture.
Set all heaters to Prog mode. The ‘‘slaves’’ heaters
will operate according to the program on the ‘‘master’’
heater and constitute a comfort zone.
Comfort and Economy temperatures need to be
adjusted on each heater link with a pilot wire to the
‘‘master’’ heater.
Using 2 Programmer modules it is possible to have 2
separate comfort zones.
WARNING
- You must not install 2 Programmer modules
units in the same comfort zone.
- It is imperative to respect the connection pola-
rities of all heaters of one zone.
L1 L2
Programmer
GROUND
L1
L2
L2
L1
PILOT WIRE
(Purple)
Heater fitted
with a Programmer
Other heaters in
the comfort zone.
(20 maximum)
CONNECTOR
MAIN
PANNEL.
)
(Black)
(Red)
(Black)
(Red)
Master heater
Slave heater
Slave heater
Pilot wire
(Purple)
PILOT WIRE
OK
Prog
PROG
1 2 3 4 5 6 7
There are 4 pre-programmed groups of days:
• 1 - 2 - 3 - 4 - 5 - 6 - 7
• 1 - 2 - 3 - 4 - 5
• 6 - 7
• 1 - 2 - 4 - 5
Note: In these group of days, Monday = 1, and so on.
Copying a program on a group of days:
ou
ou
ou
- Using a small screwdriver, press on the clip
and lift the cover of the slot (on the right hand
side next to the control panel) and insert the
Programmer module.
- Select the Prog position on the thermostat.
2 - INSTALLATION & CONFIGURATION
Note: For optimal results the Program-
mer module should remain permanent-
ly in the slot of the control panels.
Control panel
Slot designed
to receive the
Programmer
module.
a) Inserting the module into the heater:
Location
OK
Prog
PROG
6 7
OK
Prog
PROG
1 2 3 4 5
OK
Prog
PROG
1 2 4 5
Press Prog .
Select the day you want to copy the program from
using
and
and press OK to validate.
The program you want to copy is shown.
Press OK to validate.
Press
for 3 seconds.
Select the group of days on which you want
to copy the program using
and
and
press OK for 3 seconds.
The program is copied and appears on the screen.
Press OK to validate.
Exit by pressing Prog .