CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 16 -
CONFIGURATION MENUS
(1)
Input Configuration
Analog Throttle (Default = None)
Digital Input 1 - Pre Set to Auto Start
Digital Input 2 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 3 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 4 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 5 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 6 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 7 Setup (NO/NC, Action, Message, When Active, Delay)
(2)
Output Configuration
Relay Output 1 – Pre Set to Pre-Alarm
Relay Output 2 – Pre Set to Fuel/Run
Relay Output 3 – Pre Set to Alarm
Relay Output 4 – Pre Set to Crank
Relay Output 5 Setup (Function, Polarity, Initial State)
Relay Output 6 Setup (Function, Polarity, Initial State)
Relay Output 6 Setup (Function, Polarity, Initial State)
Relay Output 7 Setup (Function, Polarity, Initial State)
Relay Output 8 Setup (Function, Polarity, Initial State)
(3)
Throttle Configuration
Throttle Type Selection (Default = TSC Vernier)
TSC Mode Selection (Default = Primary)
TSC Min Speed Selection (Default = 800 RPM)
TSC Max Speed Selection (Default = 2400 RPM)
TSC Bump Speed Selection (Default = 20 RPM)
TSC Ramp Rate Selection (Default = 100 RPM/Sec)
Throttle Cure Selection (Default = Linear)
Multistate Speed 1 Selection (Default = 800 RPM)
Multistate Speed 2 Selection (Default = 800 RPM)
Multistate Speed 3 Selection (Default = 800 RPM)
Multistate Speed 4 Selection (Default = 800 RPM)
