www.ControlloCasa.it
+39 06 94804820
The following graphical interface will inform you that from now on your USBy is active!
The USBy device is now configured to send you notices of power failure and recovery.
To verify the correct operation of USBy, disconnect the power supply to USBy and after
about 5 minutes you should receive an email informing you of the power failure. Once you
have powered up the USBy again, you should receive the power restoration notice after
about 1 minute.
2.2
USBy Functionalities
This section will provide you with all of the necessary information to:
•
Retrieve USBy ID
•
Receive notices of Power failure / recovery
•
Change the email address and identification (alias) of the device
•
Check the connection status of the device
•
Check the ambient temperature
•
Update the Software
2.2.1
Retrieve USBy ID
The procedure to retrieve the identification of your USBy (i.e. USBy ID) is as follows:
1. From your PC / Mac, open the list of WiFi networks and select the network created by
USBy (e.g. USBy-V3_XXXXXX)
2. Open your Web Browser and enter the following URL:
192.168.4.1/id.html
At this point you will get back the identification of your USBy (i.e. USBy ID)
