POWER FAILURE
HOW TO DISENGAGE YOUR
CONTROLL-A-DOOR for MANUAL
OPERATION
To disengage:
3
Pull handle down firmly, then across to your left. The
door can now be used manually.
To re-engage:
Move handle towards the right.
When the power resumes:
The UP.STOP.DOWN light and No.2 light will flash.
Your transmitter code will be remembered.
Make sure the drive unit is engaged.
Press UP.STOP.DOWN (or the hand transmitter).
Allow the door to close fully. (This allows the
Controll-A-Door to reconfirm it's memory).
WARNING: THE AUTOMATIC REVERSING
SYSTEM WILL NOT OPERATE ON THE FIRST
DOWN MOVEMENT!
If the door is already closed when UP.STOP.DOWN
is pressed, or if there has been a short blackout while
you have been out, the door will try to go down, then
go up a short way and down again.
Press UP.STOP.DOWN (or transmitter) again and the
door will open normally.
DISENGAGEMENT
HANDLE
DISENGAGE
RE-ENGAGE
ACCESSORIES
WIRED REMOTE BUTTON
For fitting in the garage or inside the house.
KEY SWITCH
For use outside the garage when transmitter use is
inconvenient.
EXTERNAL DISENGAGEMENT DEVICE
Strongly recommended where the garage door is the
only access to the garage. This allows the Controll-
A-Door to be disengaged from outside the garage in
case of power failure.
ADDITIONAL HAND TRANSMITTERS
KEY-RING
TRANSMITTER
L.H.S. BUTTON