*
16
M’Ax Installation Guide
www.controltechniques.com
Issue Number: 6
2.27
Attaching the drive to the back-plate
Figure 2-10
Mounting details for the drive
1.
Back-plate with mounting holes A.
2.
Upper mounting bracket fitted to the rear of the drive.
3.
Lower mounting bracket with M5 stud S fitted to the rear of the drive.
The stud must be used for ground termination (see section
2.30 Method of connecting the power cables on page 18).
4.
If compliance with EMC emission standards is required, both
mounting brackets must make direct electrical contact with the back-
plate; the screw holes should be threaded.
5.
Area occupied by the drive.
6.
Loosely fit screws (B), locate the slotted holes in the mounting
brackets over the screws, then tighten the screws.
(9.724in)
(14.173in)
M5
M5
(0.590in)
(1.986in)
(2.440in)
(0.787in)
(0.905in)
(12.992in)
(10.748in)
11mm (0.433in)
