![background image](http://html1.mh-extra.com/html/control-4/c4-sr150rsk-b/c4-sr150rsk-b_setup-manual_2658285003.webp)
c
(Optional) To remove the power plug
adapter, press the
Push
button and slide the
plug out.
3
Insert the power plug into a power outlet to
begin recharging.
4
For convenience, place the recharging station
close to where you use your remote.
Set the Charging Indicator on Your
Recharging Station
This section applies to recharging stations for existing
or new remotes.
1
Turn the recharging station over.
2
Notice the Charging Indicator button labeled
‘High, Off, and Low’ (Figure 8).
Figure 8. Charging Indicator Button
3
Move the button to the desired light level.
• High
. Sets to the highest light level.
• Off
. Sets the light to off.
• Low
. Sets the light to low.
4
Turn the recharging station over to its upright
position.
Place the Remote on Your Recharging
Station
This section applies to recharging stations for existing
or new remotes.
1
If you purchased a recharging station
without
a remote, ensure that you’ve replaced your old
batteries with the new rechargeable batteries and
new cover.
2
While holding the remote in a horizontal position,
place it onto the charging station.
3
Ensure that it is properly seated. The two metal
remote control. You should expect this to
occur over a period of 1-2 months.
1
Insert the remote’s new battery cover into the
remote. Notice the two metal plates on the cover;
that’s how you can differentiate the old cover
from the new one (Figure 5).
Figure 5. Replace Cover
2
Slide the battery cover into the slot and then
push down until the cover is horizontal. Slide the
cover into the slot until it snaps into place.
Attach the Power Supply to Your
Recharging Station
This section applies to recharging stations for existing
or new remotes.
1
Insert the small end of the USB cable into
the back of the recharging station (inside the
indentation) and thread the power cord through
the indentation in the station (Figure 6).
NOTE:
You can thread the cord straight out
or wind it around to the opposite end of the
recharging station.
Figure 6. Insert Power Cord
2
Attach the USB cable to the power supply.
a
Remove the plastic shield from the power
supply.
b
Attach the correct power plug adapter to
the power supply by sliding it into the power
supply’s slot until it clicks into place.
3
Charging
Indicator
Button