Control 4 C4-KD120 Series, Installation Manual

Page: 1 / 4

™
Compact fluorescent (CFL)* 500 500 500
LED* 200 200 200
Minimum load (with neutral)
All load types 1W
Minimum load (without neutral)
Incandescent (tungsten) 7W
Halogen 7W
Fluorescent* N/A
Compact fluorescent (CFL)* N/A
LED*
N/A
Environmental
Operational temperature 32˚F ~ 104˚F (0˚C ~ 40˚C)
All load ratings are based on an ambient
temperature of 77°F (25˚C).
Humidity 5% to 95% non-condensing
Storage
-4˚F ~ 158˚F (-20˚C ~ 70˚C)
Miscellaneous
Control communications ZigBee, IEEE 802.15.4, 2.4 GHz, 15-channel
spread spectrum radio
Wallbox volume 5.75 cubic inches
Weight 0.12 lb. (0.05 kg)
Shipping weight 0.22 lb. (0.10 kg)
* NOTES :
(1) The maximum load requirements for fluorescent, CFL and LED loads
can vary greatly depending upon the specific fixture and/or bulb being
used. These load types have significant in-rush current which can trip the
protection circuitry on the device.
(2) The quality and performance of these load types varies greatly
from manufacturer to manufacturer. When using these load types, we
recommend testing in advance. If problems are found, simply changing to
a different bulb manufacturer may solve the problem.
(3) Additionally, we do not recommend the use of fluorescent, CFL, or
LED loads without a neutral wire connected to the dimmer due to the
capacitive nature of these load types.
(4) Wiring with a neutral is always the preferred wiring method (if
possible).
Warnings and considerations
WARNING! Turn OFF electrical power before installing or servicing this
product. Improper use or installation can cause SERIOUS INJURY, DEATH
or LOSS/DAMAGE OF PROPERTY.
ATTENTION! Coupez l’alimentation électrique avant d’installer ou de
réparer ce produit. Une mauvaise installation ou utilisation peut entraîner
des blessures graves, décès ou perte / dommages à la propriété.
WARNING! This device must be protected by a circuit breaker (20A max).
ATTENTION! Cet appareil doit être protégé par un disjoncteur (20A max.)
WARNING! Ground this device in accordance with the National Electric
Code (NEC) requirements. DO NOT rely solely upon the yoke plate’s
contact with a metal wallbox for adequate grounding. Use the device’s
ground wire to make a secure connection to the safety ground of the
electrical system.
ATTENTION! Cet appareil doit être en conformité avec le Code national
de l’électricité (NEC). Ne comptez pas uniquement au contact de la
plaque avant avec un boîtier mural métallique pour la mise à la terre
adéquate. Utilisez cet appareil à la terre de l’appareil pour établir une
connexion sécurisée au système électrique.
Supported models
• C4-KD120 Keypad Dimmer, 120V
• C4-KD277 Keypad Dimmer, 277V
Introduction
The Control4® Keypad Dimmer operates independently or as part of a Control4
home automation system. It installs in a standard back box using typical wiring
standards and communicates to the Control4 system using a wireless connection.
Box contents
• Keypad Dimmer
• Keycap Button Kit
• Wire nuts
• Warranty card
• Keypad Dimmer Installation Guide (this document)
• Keypad Button Installation Guide
Specifications and supported load types
The specifications are described below.
Model numbers C4-KD120-xx, C4-KD277-xx
Power requirements C4-KD120: /-10%, 50/60Hz
C4-KD277: /-10%, 50/60Hz
This device can function with or without a
neutral AC connection depending on load type.
Wiring with a neutral is always the preferred
wiring method (if possible). See load types and
“Sample Wiring Configurations” below.
When wired without a neutral, loads may
appear dimmer.
Power consumption C4-KD120: 786mW; C4-KD277: 2.51W
Load types and ratings
Supported load types Incandescent, halogen, electronic (solid state)
low voltage (ELV) transformers, magnetic
(iron core, inductive) low voltage (MLV)
transformers, phase-dimmable fluorescents,
compact fluorescents, and LEDs.
C4-KD120 maximum load 1 Gang 2 Gang 3+ Gang
Incandescent (tungsten) 600W 550W 500W
Halogen 600W 550W 500W
Fluorescent*
300W 300W 300W
Compact fluorescent (CFL)* 300W 300W 300W
LED* 120W 120W 120W
C4-KD277 maximum load 1 Gang 2 Gang 3+ Gang
Incandescent (tungsten) 1000 900 800
Halogen
1000 900 800
Fluorescent* 500 500 500
Keypad Dimmer
Installation Guide