™
Operation and configuration
On initial power up, all status LEDs on the dimmer will illuminate green indicating
that the device has power. To set up this dimmer for use with a Control4 system,
refer to the
Composer Pro User Guide
.
To operate this dimmer as a stand-alone device prior to configuration in Composer
Pro:
•
If the light is off, click any
button
to turn the light on.
•
If the light is on, click any
button
to turn the light off.
•
Press and hold any
button
to ramp the light up/down. Release the
button
at
the desired light level.
•
If the split up/down buttons have been installed in the bottom button slot, the
up and down arrows will ramp and fade the light respectively.
Air gap switch
During routine lamp replacement, you should remove power from the lamp by
engaging the air gap mechanism.
1
To engage, press on the right side of the top actuator bar until the left side
pops out. All LEDs on the dimmer will turn off and the dimmer will no longer
control the light when the air gap mechanism has been engaged.
2
To return power to the dimmer and lamp, press on the left side of the top
actuator bar until it snaps back into place.
Figure 3. Dimmer with actuator bar
Button tap sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single (1) button should use the top button. Button tap sequences
requiring two (2) buttons should use the top-most and bottom-most buttons
installed on the Keypad Dimmer.
Function
Button sequence
Identify
4
ZigBee channel
7
Reboot
15
Factory reset
9-4-9
Leave mesh and reset
13-4-13
Troubleshooting
If the light does not turn on:
•
Ensure that at least one (1) LED on the face of the dimmer is lit.
•
Ensure that the light bulb is not burned out and is screwed in tightly.
•
Ensure that the circuit breaker is not turned OFF or tripped.
•
Check for proper wiring (see “Sample Wiring Configurations”).
•
For help on the installation or operation of this product, email or call the
Control4 Technical Support Center. Please provide your exact model number.
Contact [email protected] or see the web site www.control4.com.
Actuator bar
Care and cleaning
•
Do NOT paint the dimmer or its wall plate.
•
Do NOT use any chemical cleaners to clean the dimmer.
•
Clean surface of the dimmer with a soft damp cloth as needed.
Regulatory/Safety information
To review Regulatory information for your particular Control4 products, see
the information located on the Control4 website at: http://www.control4.com/
regulatory/.
Patent information
Applicable patents are available at http://www.control4.com/legal/patents.
Warranty
For complete warranty information, including details on consumer legal rights as
well as warranty exclusions, review the Warranty card or visit www.control4.com/
warranty.
About this document
Part Number: 200-00308 Rev E 12/16/2013 MS
Sample wiring configurations
Figure 4. Single device location, with neutral connection (recommended)
Figure 5. Single device location, without neutral connection
