24
W415-0857 / B / 02.14.11
8.5 LOUVRE
INSTALLATION
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature
but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
When using a non-combustible fi nishing material, the stand-offs may be removed, by
removing the set screw in the centre and sliding the stand-offs out of the mounting
clips.
HEA
T SHIELD
ST
AND-OFFS
END HEAT SHIELD SHOWN
8.6 HEAT SHIELD STAND-OFF REMOVAL
Remove the backing of the logo supplied and place on the screen cover, as indi-
cated.
8.7 LOGO
PLACEMENT
A
B
C
SLOT
A
B
C
CLIPS
CENTRE SLOT
TAB
SLOT
HINGE CLIP
57.2
UPPER LOUVRES
Insert the louvre tabs
into the slots located
at the top left and right
corners of the unit.
LOWER LOUVRES
Insert the hinge clips
into the slots located at
the bottom left and right
corners of the unit. To
remove the louvres, pull
the back tabs of the clips
forward, while pushing
the louvre assembly
back. Lift the clip.
HOOD
Attach the hood by
pressing the top fl ange
into the clips along the
top of the louvre open-
ing. Secure using a
screw through the centre
slot.
