42
W415-1364 / 12.08.14
EN
7.3 LOGO
PLACEMENT
7.4 OPTIONAL ROCK KIT
ROCK SUPPORT
BRACKET
LOG SUPPORT BRACKET
!
WARNING
(RAK-ROCK ADAPTOR KIT IS NECESSARY WITH THIS KIT).
REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE.
A.
Remove all logs and media.
B.
Remove the 2 screws and log support brack-
ets already installed in the
fi
rebox and secure
the rock support bracket along the back of the
fi
rebox.
NOTE: When the porcelain panels are installed, the
rock support bracket is secured over the rear por-
celain panel. Tabs on rear porcelain panel must be
bent up to sit fl ush on the rock support bracket.
C.
Move the two rock clusters into position, lin-
ing up the studs located on the burner with
the holes in the bottom of the rocks. Ensure
the clusters are sitting
fl
at on the burner.
NOTE: For best results it's recommended
you remove the grate and using Wolf Steel
approved paint, paint the surfaces under-
neath where the grate was removed.
D.
Place the large cut out rocks along the edge of
the rock support bracket as shown.
E.
Place the remaining refractory rocks around the
burner as desired,
making sure not to cover
any burner ports.
(There are no set locations).
97.1A
Remove the backing of the logo supplied and place on the glass viewing door,
as indicated.
½"
(12.7mm)
LOGO
½"
(12.7mm)
