1. Introduction
Hardware Manual
5
-
Life expectancy of components
(1)Battery: A lithium-ion primary battery is used to back up the internal clock/calendar and CMOS
RAM. The non-energized backup time at 25°C is 10 years or more.
(2)LCD backlight: Display brightness decreases over time with use.
The operating lifetime of the backlight is 50,000 hours (the time until the
brightness is lowered to 50% of the initial value)
(3)Touch panel:
The operating lifetime of the touch panel is at least 1 million touches (as tested
by mechanical touching under 300 g of force at a rate of two presses per
second).
(4)Flash memory (NFDISK): The number of times of rewriting has restriction that is more than
300,000. (When the write size is 128KB or less.)
Since CF-CARD is used for Flash memory (NFDISK), When use is
carried out for the use that rewrites frequently, be careful of the
number of times of rewriting.
Moreover, when power supply OFF is done while writing it, data in
flash memory (NFDISK) might be damaged.
* CONTEC accepts your request for replacing each consumable in the PANECON-PC as a request
for repair (at an additional cost).
-
If installed horizontally (with the LCD panel face up), the unit should be used at an ambient
operating temperature of not greater than 30 degrees centigrade.
-
Be sure to turn off the power before plugging or unplugging any expansion board or connector.
-
CONTEC reserves the right to refuse to service a product modified by the user.
-
In the event of an abnormal condition or malfunction, please consult the dealer from whom the
equipment was purchased.
-
Use an AC cable that is compatible with both the rated supply voltage and the receptacle.
-
To connect with peripherals, use a grounded, shielded cable.
-
This product contains a lithium battery as the primary cell and a cold cathode tube for the backlight.
When disposing of the product, therefore, treat it in accordance with the disposal regulations
stipulated by your local government.
