3. Hardware Setup
Hardware Setup
-
Before you start, be sure that the power is turned off.
-
Remove only those screws that are explained. Do not move any other screw.
Attaching the Attachment Fittings
(1) Use screws to attach the bundled attachment fittings with a screw.
(The attachment fittings are attached to the product when it is shipped.)
Do not tighten screws with excess force.
* Attached screw (M3)
Figure 3.1. Attaching the Attachment Fittings
Attaching the FG
Use screws to attach the FG. (The screw is attached to the product when it is shipped.)
* Attached screw (M3)
Figure 3.2. Attaching the FG
CAUTION
The FG pin of this product is connected to the GND signal of the DC power connector (DC-IN).
Note that the connection cannot be cut off.
Screw holes may be damaged if screws are tightened with a torque greater than the specified
torque.The specified tightening torque is 5 - 6kgf
⋅
cm.
12
DS-380D Series User’s manual
Summary of Contents for DS-380D Series
