1 Before Using the Product
CPSN-MCB271-S1-041 Reference Manual (Hardware)
7
-
Avoid installing in the place where ventilation of the product may compromise. Insufficient
aeration could heat up the product and lead to malfunctions or damages.
-
Do not use the product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause the product to malfunction (stop, reboot).
-
Do not use or store the product in the presence of chemicals.
-
When removing connectors or cables, always unplug the power cable of CPU unit and confirm the
LEDs are turned off.
-
Do not modify the product. CONTEC will bear no responsibility for any problems, etc., resulting
from modifying the product.
-
In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cable of CPU unit immediately and contact your retailer.
-
When using the product in an overly noisy environment, use a grounded, shielded cable to connect
with peripherals.
-
To clean the product, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent the paint to be
scraped or discolored.
-
When connecting cables, first check the shapes of connectors, and then insert them in the correct
orientation. After they are connected, do not put too much load on the connected part. Doing so
may result in poor contact or damage to the product and the connected part.
-
Do not touch metal parts or terminals with your hands when the product is in operation. Otherwise,
the product may malfunction, or cause failure.
-
Do not touch the front panels with your hands when the product is in operation. Otherwise, the
product may malfunction or cause failure.
-
Do not touch the product or connectors with a wet hand to avoid electric shock.
-
The specifications of the product are subject to change without notice for enhancement and quality
improvement. Even when using the product continuously, be sure to read the manual in the
CONTEC’s website and understand the contents.
-
When the product is used in a place that is affected by overcurrent or overvoltage (lightning surge),
select appropriate surge protection device for all of the route (Signal line, etc.). Consult with the
specialist regarding selecting, purchasing, and setting the surge protection device.
-
The product is an open-type device (a device designed to be housed inside other equipment) and
must always be mounted inside a mechanical enclosure having enough strength.
-
Do not strike or bend this product. Otherwise, this product may malfunction, overheat, cause a
failure or breakage.
-
Do not touch this product's metal plated terminals (edge connector) with your hands. Otherwise,
this product may malfunction, overheat, or cause a failure. If the terminals are touched by
someone's hands, clean the terminals with industrial alcohol.
-
Always install the blank panels into vacant slots while power is active.
-
Regarding “CE EMC Directive Notice”.
Please connect the Interface Connector with a shielded cable to meet the mentioned standard above.
