35
Changing the bulbs
Cleaning and care
Isolate the extractor hood by pulling out
the mains plug or switching off the fuse.
q
When cleaning the grease filters, remove
grease deposits from accessible parts of
the housing. This prevents the risk of fire
and ensures that the extractor hood
continues operating at maximum effi-
ciency.
q
Clean the extractor hood with a hot soap
solution or a mild window cleaner.
q
Do not scrape off dried-on dirt but wipe
off with a damp cloth.
q
Do not use scouring agents or abrasive
sponges.
q
Note
: Do not use alcohol (spirit) on pla-
stic surfaces, as dull marks may appear.
Caution:
Ensure that the kitchen is ade-
quately ventilated. Avoid naked flames!
Clean the operating buttons with a mild
soapy solution and a soft, damp cloth only.
Do not use stainless-steel cleaner to clean
the operating buttons.
Aluminium and plastic surfaces:
q
Use a soft, non-linting window cloth or
micro-fibre cloth.
q
Do not use dry cloths.
q
Use a mild window cleaning agent.
q
Do not use aggressive, acidic or caustic
cleaners.
q
Do not use abrasive agents.
1.
Switch off the extractor hood and deen-
ergize by pulling out the mains plug or
switching off the fuse.
2.
Press the edges of the lamp cover
together where indicated and lift it out
towards you.
3.
Replace the bulb (standard filament bulb,
max 40 W, E14 bulb holder).
4.
Refit lamp cover.
5.
Reinsert mains plug or switch on the
fuse.
Faults
If you should have any questions or there
are any faults, call customer service (see list
of customer service units).
Please give the following details when you
call:
Enter these numbers in the spaces above.
You will find the numbers on the rating plate
inside the extractor hood after removing the
filter screen.
Product no. (E-Nr.)
Serial no. (FD)
Important information
Installation instructions
Old appliances are not worthless rub-
bish. Valuable raw materials can be reclai-
med by recycling old appliances. Before
disposing of your old appliance, render it
unusable.
You received your new appliance in a
protective shipping carton. All packaging
materials are environmentally friendly and
recyclable. Please contribute to a better
environment by disposing of packaging
materials in an environmentally-friendly
manner.
Please ask your dealer or inquire at your
local authority about current means of dis-
posal.
The extractor hood can be used in
exhaust air or circulating air mode.
Always mount the extractor hood over
the centre of the hob.
The minimum distance between the hob
and the lower edge of the extractor hood is
650 mm
.
The extractor hood must not be instal-
led over a solid fuel cooker – a potential fire
hazard (e.g. flying sparks) – unless the coo-
ker features a closed, non-removable cover
and all national regulations are observed.
The smaller the gap between the
extractor hood and hotplates, the greater
the likelihood that droplets will form on the
underside of the extractor hood.
Additional information concerning
gas cookers:
When installing gas hotplates, comply
with the relevant national statutory regulati-
ons (e.g. in Germany: Technische Regeln
Gasinstallation TRGI).
Always comply with the currently valid
regulations and installation instructions sup-
plied by the gas appliance manufacturer.
Only one side of the extractor hood may
be installed next to a high-sided unit or high
wall. Gap at least
50 mm
.
Summary of Contents for CD22130
Page 54: ...54 ...
Page 55: ...55 CZ5200X0 CZ5322X1 CZ5110X0 086244 088208 CZ5521X1 ...
