![background image](http://html1.mh-extra.com/html/conrad/92-20-17/92-20-17_operating-instructions-manual_2653971015.webp)
15
Putting on headset
You can put the headphone shell of the headset both on your left or your right ear. The microphone bra-
cket can be turned/swivelled in the direction concerned.
Switching headset on/off
Press and hold the on/off button so long until the LED flashes and a beep tone confirms that the headset
is now switched on.
To turn it off, press this button again so long until the LED goes out and a short beep sounds.
Plugging in headset
Before you use the headset for the first time, you have to plug the headset into the base station
which is to be used!
First of all, check the PIN code of the base station of the cordless telephone! The PIN code of the head-
set is “0 0 0 0“. Therefore, the PIN code of the base station has to be programmed to “0 0 0 0“.
For this, observe the operating instructions of the cordless telephone on which this headset is to
be used and follow the instructions described there step for step!
Take up a position approx. 1-2 metres from the base station of your telephone! Switch on the headset,
the red LED flashes! The headset is now in an inactive condition.
Press the “PARK“ button once again with a sharp object, e.g. with an unbent paper clip! (See illustration!)
This button is seated somewhat deeper in the opening so that this is not pressed by mistake. You there-
fore have to insert the sharp object carefully into the opening and then just press this button lightly (=
micro switch) (soft click)!
The red LED now flashes quickly and goes over to a flashing green one when the plug-in process on the
base station of the telephone has been completed positively. The headset is now in standby mode. If the
plug-in process has failed, repeat the complete process!
Summary of Contents for 92 20 17
Page 27: ...27...