26
11. Configuration via Text Message
To receive the full functional scope of the product, it must be configured first. Configuration is
performed by simple text message commands you send to the device (the phone number of
the SIM card in the device) from your mobile phone.
This method makes it possible to activate, deactivate or change the settings of your device
from anywhere.
To protect from unauthorised access, the product generally reacts to authenticated
messages only.
In a text message, you authenticate yourself by including the correct PIN number
(not the one of the mobile phone from which the text message was written). When
calling, the conveyed phone number must correspond to a phone number in the
phone book.
For your own safety, the PIN number must be changed under all circumstances
after commissioning of the product. This is described in more detail in the chapter
corresponding to the command.
11.1 Introduction to the Command Format
The text message to programme the device is set up according to the following chart:
<ACTION> <FUNCTION> <PARAMETER1> <…>
<#PIN>
Examples (function explanation in brackets):
SET
TEL1
+49177556644221
#1513 (phone book)
RESET
OUT1
#1513 (relay off)
TEST
IN1
#1513 (request IN1)
Important!
Every text message sent to the device must end with the PIN set as protection.
Without „#PIN“ at the end of the text message, it is discarded and no answering text
message will be generated!
The individual words and parameters must be separated by a space each.
