![background image](http://html1.mh-extra.com/html/conrad/841086/841086_operating-instructions-manual_2653672025.webp)
25
10.2.2 Wireless Remote Control Battery Change
If a battery change of the remote control is necessary, you need one 27A type battery and a
matching screwdriver.
Remove the screws on the back of the remote control to change the batteries.
10.2.3 Coupling of a Remote Control to the Device
Deletion of the current and coupling of a new remote control is possible as follows:
Delete the old wireless remote control:
When a remote control is lost, the entire stored encryption must be deleted.
• Press the programme switch (see figure in chapter 8, item 12) with a pointed object and keep
it pressed for approx. 10 seconds
• The red RF status LED (see figure in chapter 8, item 4) flashes 2x.
• Push the programming switch (12) briefly again.
The remote controls stored can only be deleted together. Deletion of a single
remote control is not possible.
Teaching in one or several remote controls:
• Press the programme switch (see figure in chapter 8, item 12) with a pointed object and keep
it pressed for approx. 3 seconds.
• The red RF status LED (see figure in chapter 8, item 4) will flash briefly.
• Now push any key of the remote control.
• After the first push, the red LED will light up briefly; after the second one, it will remain lit
longer. This signals that the remote control is stored now.
Up to 7 remote controls can be coupled with the product.