57
r) Temperature unit
For the display of the measuring values for temperature either the unit “C” (= °C, degree Celsius) or “F” (= °F, degree
Fahrenheit) may be used.
Select the desired funtions with keys “
W
” or “
X
” and confirm the selection with the “ENTER” button.
For the setting of the temperature unit in the display of the outdoor sensor the “°C/°F” (19) button in
the battery compartment of the outdoor sensor must be used.
s) Weather forecast
Here, after initial start-up, you should set the current weather in order to make the display of the weater forecast
symbols more accurate.
Select the current weather with the arrow keys “
W
” or “
X
” and confirm the setting with the “ENTER” button.
t) Air pressure unit
For the display of the air pressure values you may either use the unit “hPa”, “mb”, “inHg” or “mmHg”.
Select the desired unit with keys “
W
” or “
X
” and confirm the selection with the “ENTER” button.
u) Outdoor sensor
Here you can adjust if the display for the outdoor temperature/air humidity is changed automatically if more than one
outdoor sensor is registered at the weather station (this is shown as “CH1”, “CH2” and “CH3” in the display).
Alternatively, a defined outdoor sensor can be selected for the display. The channel numbers correspond to the
sending channel that is preset in the outdoor sensor via the switch (20); see also chapter 9. c).
Select the desired setting with the keys “
W
” or “
X
” and confirm it with the “ENTER” button.
v) Default settings
Here you can reset the settings to the factory defaults.
Press the “ENTER” key and a security query will appear. With the keys “
W
” or “
X
” choose between “
5
” (restore
default settings) and “X” (Cancel, back to the setup menu) and confirm the choice with the “ENTER” button.
w) S/W version
At this point, only the firmware version of the weather station is shown; no settings are possible.