![background image](http://html1.mh-extra.com/html/conrad/64-64-22/64-64-22_operating-instructions-manual_2654369031.webp)
31
• Operation with Double Channel Number
Each button is assigned to a different channel. The transmission of a command is signalled
by the short lighting of the control light LED.
Switching
A short press of a button (shorter than 0.4 seconds) sends a switching signal.
The contacted transmitter changes its switching status with each button press, i.e. from
"OFF" to "ON" and/or from "ON" to "OFF".
Dimming
If a button is pressed for longer than 0.4 seconds then the command for dimming up or
dimming down will be sent until the button is released again (lamps will be dimmed up to their
maximum and then dimmed down to minimum etc.).
The dimming direction changes with every new button press. If, for example, you dimmed
up with the last long press of the button, then the next long press will dim down.
• Timer programming with Double Channel Number
Proceed as follows to program a receivers to the timer function:
Press (and hold!) the button assigned to the receiver. Press the button next to it for one to
five seconds (1s to 5s) and then release it again. Then release the button you pressed and
held first.
This command procedure starts the timer programming and also ends it when
you are finished. The actual programming of the timer is to be carried out in
accordance with the respective operating instructions of the receiver.