![background image](http://html.mh-extra.com/html/conrad/56-15-99/56-15-99_operating-instructions-manual_2654137045.webp)
44
Connection diagram of the connection terminal:
☞
When using alarm sensors, you must refer to the chapter „11.17.1 Submenu SEN-
SOR SETUP“.
Image A1
Connection RS485:
The connection RS485 is intended for a suitable PTZ camera.
This is not part of the delivery and separately available.
Connections SENSOR:
You can connect sensors with NC or NO contacts to the sen-
sor connections 1 to 4.
Also observe the chapter „11.17.1 Submenu SENSOR SET-
UP“.
Connection “ALARM“
On the connection ALARM, you can e.g. connect an optic or
an acoustic signal transmitter. The connection ALARM is an
NO relay contact.
The device initialises after the LCD monitor with digital recorder.
During the initialisation, the production date of the firm-
ware as well as the version number are displayed.
Afterwards, the LCD monitor with digital recorder
searches for the installed hard disk and shows the mod-
el number of the hard disk after successful search.
If there is a power failure during recording, the LCD
monitor with digital recorder tries to return to record
mode when the power is restored.
Summary of Contents for 56 15 99
Page 129: ...128 ...
Page 130: ...129 ...