![background image](http://html1.mh-extra.com/html/conrad/19-04-86/19-04-86_operating-instructions-manual_2653769036.webp)
36
d) Setting the Running Light Speed
In addition to the light sequence, you can also set the running speed of the 16-channel running
light control. There are 26 speed levels available for this.
To set the desired running direction speed, proceed as follows:
• Switch on the 16-channel running light control.
• Hold down the mode button SW 2 until the LED display “LED1” (see figure 8) is lit
permanently
• Now let go of the node button SW 2. The LED display continues to be lit.
• Press the mode button SW 2 again to decelerate the running light speed by one step. If you
already called the slowest speed, the running light control starts again at the fastest possible
speed of the SW 2 mode button is pressed again.
• Confirm the mode button SW 2 until you have set the desired running light speed.
• To leave the speed settings, hold down the mode button SW 2 until the LED display goes
out.
• To store the set speed, hold down the mode button SW 2 until the LED display flashes.
The set and stored running light speed affects all light sequences equally. Applying
a speed setting only to certain light sequences is not possible.