www.connects2.com
www.
aerpro
.com
8
INSTALLATION
It is necessary to code the Park Assistant of the PCM 3.1 to retrofit factory PDC.
1.
Turn on ignition
2.
Wait until the head-unit has booted up
3.
Press and hold ‘Back’ on the steering wheel
4.
Press and hold ‘Accept’ on the steering wheel
5.
Hold both buttons. During configuration the red and blue LED will flash
inside the CAN-box (visible at the male 8pin Molex connector).
The PCM will reset after 5-10 seconds
6.
Disengage both steering-wheel buttons
7.
When coding is successful, the red and the blue LED inside the CAN-
Box will light up and the notice ”Park Assistant“ will appear in the menu
Decoding of the Park Assistant (only PCM3.1)
It is possible to decode the Park Assistant as follows:
1.
Turn on ignition
2.
Wait until the head-unit has booted up
3.
Press and hold ‘Back’ on the steering wheel
4.
Press and hold ‘Hang Up’ on the steering wheel
5.
Hold both buttons. During configuration the red and blue LED will flash
inside the CAN-box (visible at the male 8pin Molex connector).
The PCM will reset after 5-10 seconds
6.
Disengage both steering-wheel buttons
7.
When decoding is successful, the red and the blue LED inside the CAN-
Box will light up and the notice “ParkAssistant“ disappears in the menu
