www.
aerpro
.com
www.connects2.com
7
It is necessary to code the rear-view camera input of the PCM 3.1 for use of an
aftermarket camera
1.
Turn on ignition
2.
Wait until the head-unit has booted up
3.
Press and hold steering-wheel button HASH KEY/MODE
4.
Press and hold steering-wheel button ACCEPT
5.
Hold both buttons. During
configuration the red and blue LED
will flash inside the
CAN-box (visible at the male 8pin
Molex connector). The PCM will
reset after 5-10 seconds
6.
Disengage both steering-wheel
buttons.
7.
When coding is successful, the red
and the blue LED inside the CAN-Box
will be lit and the notice, “Rear-view
camera“, will appear in the menu.
Optionally coding of ParkAssistant to retrofit factory PDC (only PCM3.1)
BACK
HANG UP
HASH KEY/MODE
ACCEPT
Steering-Wheel Buttons Left
Steering-Wheel Buttons Right
INSTALLATION
