Vpot-30 iPBX
- System Manual
2.2
Turn X200E Server On / Off
2.2.1
Turn on X200E Server
The X200E server can be turned on by pressing the power button once. After the power
indicator, blue colour LED lite, the system will be ready about 1 minutes later.
2.2.2
Turn off X200E Server
The X200E server can be turned off by pressing the power button once. After pressing
the power button, the system will start to shut down and will turn off about 1 minutes
later. The power indicator, blue colour LED turns off indicates the X200E server is
actually turn off.
WARNING: Don't remove power while the server is operating. It requires proper shut
down by press the power button once as stated above.
2.2.3
Restart X200E Server
In order to restart X200E server, following the above procedure to turn off it, wait for 10
seconds and then turn on it again.
2.3
Firewall Setting
Since most of the network has a firewall between internet and system LAN. As in the
above network configuration examples, X200E server are accessing the internet behind
a firewall. In order to make X200E server successfully communicates with other parties
in the internet, the firewall should be configured to pass specific information to X200E
server. The followings are X200E server required port forwarding setting for different
services it provide.
Service
Protocol
Port Forwarding to X200E Server
ITSP (HKBN 2b) Signaling
UDP
5060
ITSP (HKBN 2b) Voice
UDP
10000 ~ 20000
Remote E800H IP Phone
UDP
4569
Remote administration
TCP
20022
Remote system phonebook
TCP
443
Table 1: Firewall Port Forwarding for X200 Server
4
