2
5.
Prior to each use, perform the following:
•
Inspect all equipment for proper
operation.
•
Ensure all attachments and accessories
are correctly and completely attached
to the handpiece.
•
Perform the required Performance
Tests for each associated handpiece
prior to each use.
6.
Do not
use burs for
plunge cutting. Injury or
damage may occur.
1.2.2
Cautions
1.
Handpieces are factory
sealed.
Do not
disassemble
or lubricate, as this may
void the warranty. There are no user-
serviceable parts inside.
2.
Use only associated ConMed Linvatec
attachments and accessories (i.e. drill bits)
as defined within the descriptions of each
attachment.
3.
Handle all equipment carefully. If any
equipment is dropped or damaged in any
way, return it immediately for service.
4.
Never operate the MicroPower High Speed
Drill without a bur and appropriate bur
guard in place and the
collet locked
.
Damage will occur.
5.
Do not stall handpieces, damage can occur.
6.
Do not handle the handpieces by the cord.
Do not pull on the cord to remove it from
the handpiece or controller. Use the connec-
tor portion of the cord for disconnection.
7.
Do not excessively bend or kink the hand-
piece cord. Always inspect cords for signs
of excessive wear or damage.
If wear or
damage is found, discontinue use and
replace immediately
.
8.
Always inspect for bent, dull or
damaged burs, blades or drill bits
before each use. Do not attempt to
straighten or sharpen. Do not use if
damaged. After use, dispose of properly.
9.
Always use a bur of the proper length for
the specific guard.
10. Bur and neuro guards should be checked
frequently. Overheating can occur if bur
guard bearings are worn or not kept clean.
Follow the recommended maintenance
schedule on page 20.
11. Perform the following steps to verify guards
are in good operating condition.
NOTE: Bur and neuro guards are to be
returned to the factory or a ConMed
Linvatec authorized service facility for rou-
tine maintenance every six (6) months.
(a) Remove the guard from the handpiece
and insert a bur into the nose of the
guard.
(b) While holding the bur, spin the guard.
The guard should spin freely around
the bur shaft without resistance.
Summary of Contents for Hall MicroPower 6020-026
