EN
4
Figure 8
Adjusting head plate width
As shown in Figure 7, pull the control lever
to adjust the width of the head plates.
Figure 10
Drop operation
Figure 7
Extended leg segment adjustment
For adjustment of the height and length of the
foot rest, loosen the correct knob as shown
below. Then slide the section up/down to adjust
height or out/in to adjust distance up to 18cm or
height to 18 degrees (Figure 11).
Lift the pull rod with one hand to activate the drop
and then press down on the bed section to achieve
the effect of the drop pressure. (Figure 8)
Figure 11
Drop Tension adjustment
Use the black knob on the side as indicated
below. The tension direction is indicated on the
knob (Figure 9).
Bed traction position adjustment
Adjust the black knob indicated by the arrow,
and the middle section of the bed can be
horizontally displaced by 16cm. (Figure 12)
Figure 9
Adjustment of bed middle section angle
The middle section of the bed is raised and adjusted.
Hold the part shown in the figure with both hands
and pull it up. The angle of raising the waist rest is
shown in the Figure below. Maximum angle is 15 degrees.
(
Figure 10
)
Figure 12
control lever
