EN
3
EL08 Base Chiropractic Table
OPERATION
Connect the bed to an electrical outlet using the power
cord.
Moving and adjusting the table
The bed bottom frame is equipped with two control
casters and two adjustable feet.
Empty the head of the bed and make sure that the
casters at the rear of the bed are active.
Figure 1 Caster position
When the table top is lowered, the bed is in a stable
status.
The column at the front side of the base frame is
equipped with feet for adjusting the height. After
moving, please confirm whether the two adjusting
feet are in full contact with the ground, otherwise
rotate the feet for adjustment.
Please make sure that there are no objects in the
space under the table before any operation.
The table should be placed at the lowest level to
reduce the risk of injury caused by the patient
falling off the table when unattended.
Figure 4 Lifting the table
Adjusting height of head plate
Pull the control lever (in the direction indicated by
the arrow) to adjust the horizontal height of the
head plate.(Figure 5)
Figure 2 Adjustable feet of the table
Lifting the table
The height of the table can be adjusted by the
foot switch. Figure 3 shows the appearance of
the foot switch.
Figure 3 Foot switch
Adjusting head angle and head drop
operation
●
Lift up the pull rod
①
in Figure 6 to
adjust head plate angle.
●
Lift up the pull rod
②
in Figure 6 to
activate the head plate drop section. Then
press down on the head plate to achieve the
effect of the drop pressure.
The table can be lifted or lowered by the foot
switch. Step on the left or right button of the foot
switch respectively to adjust the height of the
table.
When the required height is reached (Figure 4),
release the button to stop.
①
Figure 6
②
Figure 5
