37
6.3
MOUNTING THE CARTRIDGE FILTER WITH PRESSURE
REDUCER
The built-in rotary flange for the cartridge filter with pressure reducer is supplied with bayonet drill holes.
The necessary seals and screws for this cartridge filter with pressure reducer have already been mounted.
Do not unscrew the screws!
/
Insert the four flange screw heads through the bayonet drill holes on the built-in rotary flange (see
/
Turn the cartridge filter with pressure reducer in a clockwise direction as far as it will go (see fig. 5 II).
/
Tighten the two screws in the front alternately with an Allen key (see fig. 5 III).
The pipes must be able to safely support the cartridge filter with pressure reducer. Otherwise mechanical
damage or fractures/bursts can occur in the pipes. This can result in major water damage.
Persons close to the cartridge filter with pressure reducer are exposed to a health risk due to the large
quantities of water released.
Therefore, if necessary, the pipes must be additionally fixed or supported.
Select the torque (approx. 6 Nm) so that the gasket closes and the cartridge filter
with pressure reducer is not damaged or strained!
Fig. 5: Installing the cartridge filter with pressure reducer
The unit may only be installed by skilled personnel. The chapter 4.1 “INTENDED
USE” must always be observed!
I
II
III
2.
1.
Summary of Contents for CLEAR 2.0 KD Series
