36
Safe-Lec 2 Conductor Bar Manual
SECTION 23 - ASSEMBLY FOR 1, 2, 3, & 4-WAY PICKUP GUIDE
Assembly Instructions
1. Remove nut, lock washer, and flat washer.
2. Remove transfer caps from pickup guide.
3. Fit transfer caps on to the ends of the conductor bars.
4. Ensure any hanger clamps are at least one meter back from the transfer caps.
5. Squeeze transfer caps together and fit pickup guide over support stud.
6. Fit transfer cap support bracket over support stud.
7. Fit nut, lock washer, and flat washer in order shown.
8. Tighten nut to a recommended torque of 28.4 Nm. (20-21 ft-lbs).
9. Remove nut, lock washer, and flat washer.
10. Fit bracket over bolt.
11. Fit nut, lock washer, flat washer.
12. Tighten nut to a recommended torque of 28.4 Nm (20-21 ft-lbs).
NOTE
• Bracket width must not exceed 40mm (1.55”).
Figure 36-1
1. Support Stud
2. Nut
3. Lock Washer
4. Flat Washer
5. Bolt
6. Nut
7. Lock Washer
8. Flat Washer
NOTE
• When using pick-up guides, you must use collector
part number XA-577973. Please contact factory when
ordering.
