Safe-Lec 2 Conductor Bar Manual
33
SECTION 20 - ASSEMBLY OF ISOLATION SPLICE ASSEMBLIES
Tools Needed:
• 10mm A/F open ended wrench
Installation
1. Fit bolt into joint plate. Ensure tab captivates the head on the setscrew.
2. Slide bolt and joint plate into conductor bar ends respectively.
3. Place cap over bolt.
4. Fit washers and nuts in the order shown.
5. Tighten nuts to a recommended value of 8 Nm (5-6 ft-lbs).
Note:
Tab wings must be
faced upwards.
Figure 33-1
1. Nut
2. Washer
3. Cap
4. Bolt
5. Joint Plate
6. Conductor Bar
7. Conductor Bar
