EN
90
VR2000
Side brushes
You can easily check the side brush condition and if necessary,
remove the dirt
• Turn the vacuum robot upside down.
• Remove the screws with a screwdriver.
• Use scissors to remove hair and other dirt.
Side brush bristles can be damaged (frayed) during transport or by
while in unsuitable conditions. Inserting the bristles in hot water
will straighten them to their original state.
In case of damage to the side brushes, they can be replaced with
a new one. Replacement side brushes may be performed by an
authorized service centre.
• Turn the vacuum robot upside down.
• Remove the screws with a screwdriver.
• Remove the damaged brush and replace it with a new one.
• Tighten the screw using a screwdriver.
Warning:
Make sure the brush is placed on the right side of the vacuum robot
The main brush
To remove the brush from the cover, push the brush cover release lever. Then clean the brush from hair and
other dirt.
OK
renewable
Replacement necessary
