Concept2 SENTINEL S55 v6, Installation And Operation Manual

Page: 26 / 31

25
Miscellaneous
8
8.1 GLOSSARY
Item Meaning Explanation
Alarm Smoke Screen alert input Signal from Alarm panel or SSI to Smoke Screen
Activation Smoke Screen making fog
Dip switch PCB mounted on/off switch
Drop-in anchor M8 fixing for blind holes in masonry
ESM Energy Saving Mode
A slight reduction in running temperature when “Unset”
that reduces the power consumption
Hold-off Final trigger before activation PIR or another device such as a door contact
Invert Trigger Mode
Changes the alarm input requirement between
n/o and n/c
Live Status The current status of the Smoke Screen
Faults, inputs and settings shown on the LCD (see Section
7.1)
n/c Normally closed Output status
n/o Normally open Output status
Panic A single input that will activate fog.
Panic Time Time set for a panic activation
PB SW1 Push Button switch PCB mounted activation test switches
PIR Passive InfraRed Motion detector
Screen Sensor
A device that can be used to maintain a fog
density after an activation
Set Smoke Screen Alarm / Disarm input Signal from Alarm Panel or SSI to Smoke Screen
SM Service Mode Smoke Screen is isolated for repair/installation
Settle Timer
Time after the Smoke Screen is Set during
which it will not react to a Hold-off input
Use for PIR settling time on exit.
Smoke Fog
The Smoke Screen makes a fog rather than produces
smoke
Smoke Delay
Time after an activation demand before the
Smoke Screen activates
Smoke Mode
Setting that varies the intensity of the initial burst
of smoke
Smoke Time Time set for each activation
SSI Smoke Screen Interface Isolating key-switch with status indications
TCO Thermal Cut Out Mechanical safety trip in case of heater block overheat
Temp Status The Smoke Screen block temperature
Indication if the Smoke Screen is at operating temperature
(see “Live Status” at Section 7.1)
Thermocouple Temperature sensor Gives the heater block temperature to the PCB
Trigger
One of the activation conditions of the Smoke
Screen
Unistrut Metal suspension bracket
Unset Smoke Screen not in operation Signal from Alarm Panel or SSI to Smoke Screen
Verification Output indication of an activation Smoke Screen making fog
Verify Timer
Time that the verification output maintains a
change of state after an activation is initiated
WEEE Waste Electrical and Electronic Equipment