EN
18
RK4020
PRODUCT DESCRIPTION
1. Lid
2. Kettle body
3. Water mark
4. Button to open the lid
5. Handle
6. Switch
7. Power indicator
8. Supply cable base
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliances by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
• Prior to switching the appliance on, make sure the lid is closed properly. To avoid scalding, do not open the lid
during heating.
• We do not recommend using the kettle for heating liquids other than water.
• Do not switch the unit on without water. If an empty kettle is turned on, the safety fuse will deactivate it
automatically. Let the kettle cool, then fill it with cold water and you may use it again.
• Extra care should be taken while opening the lid when refilling the hot kettle with water.
• Take precautions to avoid scalding with hot water while handling the kettle. Always hold the kettle by the handle,
as the vessel can be hot and may burn you.
• Pour the hot water slowly – excessive tilting may cause the water to flow through the lid –
RISK OF SCALDING!
• Do not use abrasive or chemically aggressive substances to clean the appliance.
• Do not use the unit if it does not operate properly, or if it has been dropped, damaged or exposed to any liquids.
Have the appliance tested and repaired by an authorised service centre.
• Never use the appliance if the supply cable or plug has been damaged; have the defect repaired immediately by
an authorised service centre.
• The appliance is not designed for outdoor use.
• The appliance is intended for household use only, not for commercial use.
•
Do not immerse the supply cable, the plug, or the appliance itself in water or any other liquid.
• Never repair the appliance yourself. Instead, contact an authorised service centre for repair.
Failure to follow the manufacturer‘s instructions may lead to refusal of warranty repair.
1
2
7
3
6
4
5
8
EN
19
RK4020
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (7), press the button for opening the lid (4), open
the lid (1), and fill the appliance with cold water within the
permitted maximum
only. If the water level in the kettle is under the recommended minimum, the kettle
will keep overheating and turning off prematurely.
Note:
Make sure that the lid (1) is closed properly, otherwise the kettle can not turn
off automatically
2. Place the kettle on the base (7); electric contacts will get connected automatically.
Thanks to the central connector design, the kettle can
turn around 360°
and be put
on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (6).
A control light on the switch (6) signals the kettle is in operation. The kettle lid (1)
must be properly closed when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed. Hot
steam could scald you!
5. After the boiling point has been reached, the kettle will turn off automatically, and
the operating light will go out. Water heating can be terminated prematurely by
moving the switch (6) to the off position.
6. Remove the kettle from the base (7) and use the hot water.
7. If you want to reheat the water you have just finished boiling, wait for approximately
30 seconds before reactivating the switch (6).
8. The kettle filter captures all potential impurities while pouring water.
Note: It is not a sign of a defect when a small amount of water droplets appear on the
kettle base (7). It is a small amount of condensed steam, which deactivates the kettle
thermostat.
CAUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then pouring it
out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
CLEANING AND MAINTENANCE
Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the
appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as
they may damage it.
Never clean the unit under running water; do not rinse it or submerge in water.
Limescale removal
Impurities from water build up during normal use. These sediments can be removed
Obr. 1
Fig. 1
PRODUCT DESCRIPTION
1. Lid
2. Kettle body
3. Water mark
4. Button to open the lid
5. Handle
6. Switch
7. Supply cable base
EN
22
RK405x
4
5
6
3
2
7
1
