Concept2 MNV4745, Manual

Page: 161 / 174

161
EN
MNV4745
Adjusting door spring strength
• The spring strength is preset only for the appliance door itself. After attaching the cover plate the weight of the
door changes.
• You adjust the strength of the springs using the screws located on the bottom part of the front of the dishwasher
(Fig. 16).
• Setting of the springs is correct when the open door stays in the position and does not fall down.
Fig. 16
When installing the appliance, follow these steps:
1. Remove all the packaging and marketing materials before first use.
2. Fasten the cover plate to the appliance door. Use the fastening screws and brackets.
3. You adjust the strength of the springs (left and right) using the screws located on the bottom part of the front
of the dishwasher (Fig. 16). To increase the strength turn clockwise. To decrease the strength turn counter
clockwise.
4. Connect the inlet hose to the water supply according to Fig. 18.
5. Connect the drain hose according to Fig. 19.
6. Stick the condensation belt under the kitchen top (step 3). Make sure that the condensation belt is stuck
alongside the edge of the kitchen top.
7. Place the dishwasher into the prepared space.
8. Use the feet at the front and back of the appliance to level it to a horizontal position. Adjust the back feet by
turning the screw on the bottom of the front side of the appliance (step 5). Adjust the front feet by turning
screws located near the feet themselves (step 5B). Use a spirit level Fig. 17).
9. Plug the power cord in the wall outlet.
10. The appliance must be secured after placing and levelling it. Securing the appliance can be done in two ways: