71
MN8560
EN
DISHWASHER CONNECTION AND ASSEMBLY
General
The dishwasher has to be expertly connected to ensure its proper operation. The data for water input and
output and electric parameters must correspond to the data indicated in the technical parameters or assembly
instructions.
• When leaving your apartment for a longer period of time, run a dishwashing program with the dishwasher empty;
once the program is over, disconnect the power supply cord from the electric socket, close the water tap, and leave
the door slightly open to prevent dampness and odour from accumulating inside. The ajar door also prolongs the life
of the door seals.
• If the appliance is to be relocated, keep it in the vertical position during transfer. If this is impossible, turn and move it
onto its back side.
• Impurities accumulated around individual seals are one of the sources of odour. Check them and wipe with a wet
cloth if needed.
Fig. 17
Drain hose connection
Connect the drain hose:
a) to the drain tube 40 mm in diameter with a vent,
b) or use the supplied adapter allowing drainage into a sink tub or a bathtub.
Note:
When used, the adapter must be fixed properly. Otherwise, it may come loose and water may spill on the
floor.
c) or use the siphon side hose of the sink or basin. Fix the hose to the lower side of the worktop. Thus, the water is
prevented from flowing back into the dishwasher.
The end of the drain hose should be 400-1000 mm (Figure 17) above the floor, and not immersed in water to
prevent water back flow.
Make sure the hose is not bent or jammed to prevent the water supply from becoming reduced or stopped.
Summary of Contents for MN 8560
Page 2: ......
