68
MN8560
EN
Note:
When no temperature is indicated for the program phase, the dishwasher does not heat water in that phase.
Note:
For a lightly loaded dishwasher, using the next weaker program is adequate.
Program
Type of soiling
Program stage
Dishwashing detergent
amount
Pre-wash/wash
Washing
time (min)
Energy
consumption
(kWh)
Water
consumption
(l)
For rinsing dishes
that will be washed
later
Rinse
20g
8
0,01
3,5
For dishes for which
rinsing and slight
drying is enough
Pre-wash (50°C)
Wash (60°C)
Rinse (60°C)
Drying
5/30 g
or 3-in-1
60
1,15
10
Accelerated program
for less dirty dishes
that do not require
drying
Wash (40°C)
1. Rinse
2. Rinse (45°C)
20g
40
0,6
10
Soak
Program information
The stated data applies under normal conditions.
Major diff erences may occur due to:
• Diff ering amounts of dishes,
• The incoming water temperature,
• The water mains pressure,
• The adjacent temperature,
• The voltage tolerance in the mains,
• By deviations in the dishwasher‘s operation (e.g. the temperature, water quantity etc.).
Dishwashing procedure
1.
Open the dishwasher‘s door
2. Check and, if needed, add salt or the rinse aid.
3. Pull out, fi ll, and push in racks in an orderly manner.
4. Put the relevant amount of dishwashing detergent into the corresponding compartment of the container.
5. Open the water tap up fully.
6. With a slight push close the dishwasher door.
7. Turn on the dishwasher by pressing the main switch (5). All symbols and indicator lights will be illuminated for a moment.
8. Select the required program by repeatedly pressing the P pushbutton (3). The expectant duration of the program
shows itself on the display.
9. By pressing the ALT pushbutton, it is possible to select the use of the upper spray arm, the lower spray arm, or both
spray arms.
10. If a delayed dishwashing start is needed, repeatedly press the delayed-start pushbutton (3) in order to set up the
required time of delay (up to 12 hours).
Summary of Contents for MN 8560
Page 2: ......
