54
ETV8860
EN
• To clean the glass of the oven door do not use coarse abrasive cleaners or sharp metal scrapers, since they can scratch
the surface or the glass can be broken.
• Never leave aggressive or acidic substances (lemon juice, vinegar) on the enamelled, varnished or stainless parts.
• Do not use an autoclave to clean the unit!
• The baking pans may be washed in a dishwasher.
UNIT INSTALLATION
• Only the customer is responsible for installation in situ. Defects caused by incorrect installation are not covered by the
warranty.
•
Do not lift the unit by holding it by the handle of the door!
•
WARNING!
Some edges of the unit that are hidden after the installation may be sharp! Proceed with caution to
prevent an injury!
• The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
• To ensure the correct function of the unit, place it in suitable furniture.
• The unit should be installed in standardised kitchen furniture designed for built-in appliances or in properly adapted
furniture of dimensions according to Fig. 8.
• The kitchen furniture must be made of sufficiently heat-resistant material. The materials and adhesives used must be
resistant to heating of the unit according to standard ČSN EN 60335-2-6. Materials and adhesives that do not meet
the stated standard may deform or loosen.
Connecting to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate. We recommend
using a separate outlet circuit with a 16A circuit breaker.
• Use grounded wall outlets with safety pin only.
• Do not use adapter plugs, connectors or extension cables. They could create a risk of fire due to overheating.
• The supply cable plug or the circuit breaker has to be freely accessible even after the installation of the unit.
• Only a qualified expert can perform connection changes.
• The electrical safety of the unit can only be guaranteed if the protective terminal of the unit is connected to the
protective conductor of the mains.
• The manufacturer bears no responsibility for damage caused to people or objects as a result of a missing or bad
protective connection.
• The power cord must be located so that it does not come into contact with hot parts of the unit and so that it is not
deformed and excessively bent.
Follow the installation instructions:
1. Remove all the covering and marketing materials from the unit before the first use.
2. For the sake of efficient air circulation the unit has to be located according to the dimensions on Fig. 8 and the design
of the cabinet must enable air flow into its bottom part. The gap behind the rear wall of the built-in oven must be at least
50 mm.
