Concept Smoke Screen Sentinel S70, Installation And Operation Manual

Page: 4 / 16

Page 4 of 16
INTRODUCTION
Before commencing installation of the Smoke Screen ensure that you have all of the following
equipment supplied in the box:
1 x Smoke Screen
1 x Wall Mounting Bracket
1 x Smoke Fluid Bag (Boxed)
2 x 12v Batteries.
1 x Literature Pack & Warning Sign
You will also require:
230-volt mains supply and connections into the Alarm Panel or other triggering system.
PIR (or equivalent) to provide the hold-off where required.
OVERVIEW
The Smoke Screen is designed to form part of an existing intruder alarm system but may also be
configured as a ‘stand-alone’ system. A ‘standard’ installation is shown in the following schematic:
STANDARD INSTALLATION
A ‘standard’ installation is configured in the following way:
The Smoke Screen wall or ceiling mounted in the appropriate location.
A Hold-off PIR (or similar device) located within the same area as the Smoke Screen providing a
confirmation signal to the Smoke Screen
to start ‘smoke’ production.
A Set command supplied by an Alarm Control Panel, or equivalent, in the form of an N/C ( Normally
closed ) relay opening when the Alarm system is set for operation.
A Trigger command supplied by the Alarm Control Panel, or equivalent, in the form of an N/C
( Normally closed ) relay opening when the Alarm system confirms an intruder alert.
Remote
Keypad
Intruder Alarm
Control Panel
Alarm Hold-off
PIR (or similar)
Alarm Hold-off
Micro switch
Intruder
Status
Verification
Secondary
User
Interface
Set
Smoke
Screen