Page
6
of
16
ACCESS
To access the PCB connections and programming panel (battery and fluid bag access covered in
the relevant sections) remove the front cover by unscrewing the 2 set screws on either side and
unhooking it from the top of the case; refitting is the reverse process. Installation cable entry is
through the serrated grommet on the left back of the case.
MOUNTING
The Smoke Screen can either be ceiling mounted, or wall mounted, using the bracket supplied. If
ceiling mounted, it is recommended that the Smoke Screen is suspended on 2 lengths of M8 studding
from a Unistrut section (pictured). In all cases, the installer must fit the Smoke Screen using appropriate
fasteners.
Suspension Kit
(All M8)
Uni-strut 1 x 1 metre
Threaded bar 2 x 1 metre
Fixings:
2 x 38mm washer
4 x 25mm washer
6 x full nut
2 x drop-in anchor
2 x channel nuts,
Wall mounting
Wall mounting is achieved using a simple wall bracket (1). The bracket should be attached to a
suitable wall. Use appropriate fixings to secure the bracket to the wall. We recommend as high a
fixing as possible for aesthetic and security/anti-tamper reasons, but no higher than 3 metres
above the floor. Fit the angle brackets to the Smoke Screen with 4 x set screws and put 2 more
set screws a few threads into the top holes (2 & 3). Carefully locate the Smoke Screen on the
bracket locating the top set screws onto the wall bracket hooks, add 2 set screws to lock the unit
and tighten all four (4).
1
3
4
2
Summary of Contents for Sentinel S70
Page 15: ...Page 15 of 16 INSTALLER NOTES ...
