Concept Pro VXM4-4, User Manual

Page: 23 / 48

20
CONFIGURING THE VXM4
CONFIGURING THE VXM4
SYSTEM: SYSTEM MANAGEMENT
F/W version: Shows the firmware version of the VXM4
H/W version: Shows the hardware version of the VXM4
VIDEO SIGNAL TYPE: The video input type is determined by the PAL/NTSC switch on the rear panel.
DISK CAPACITY: The first value shows the amount of hard drive capacity used by recorded footage,
the second value shows the total hard drive capacity installed.
IP ADDRESS: Shows either the manual IP address entered in NETWORK setup or the IP address
assigned by a DHCP server if enabled
MAC ADDRESS: Shows the MAC (Media Access Control) address of the VXM4. It is unique – no other
network device has this MAC address
SYSTEM NAME: A system name of up to 10 characters can be defined. It is used so that notification
emails can be identified.
F/W UPDATE: Firmware updates may be released periodically to enhance system performance and
add extra features. The operator can upgrade the firmware using a USB memory stick
FACTORY DEFAULT: If settings have been changed which cause erratic behaviour, the factory default
settings can be loaded
BACKUP USER DATA: System settings can be saved to a USB memory stick. The settings can be
reloaded in case of accidental factory reset or can be transferred to another VXM4 if multiple units
need to be installed with the same settings. All information is saved apart from network settings and
system name.
Although not yet supported, the VXM4 is currently being developed for use with a VA-KBDPRO
controller. This will allow up to 254 VXM4s to be controlled from the same keyboard
SYSTEM ID: If more than one VXM4 is connected on the same RS485 bus, each one must have a
unique ID
KEYCONTROLLER PROTOCOL: Must be set to VA-KBDPRO
KEYCONTROLLER BAUD RATE: Must be set to match the baud rate of the VA-KBDPRO PTZ
controller
SYSTEM: CONTROL DEVICE