Comtrend Corporation CT-6382T, User Manual

Page: 91 / 138

7.1.2 MAC Filter
This MAC Filter page allows access to be restricted/allowed based on a MAC address.
All NICs have a unique 48-bit MAC address burned into the ROM chip on the card.
When MAC address filtering is enabled, you are restricting the NICs that are allowed
to connect to your access point. Therefore, an access point will grant access to any
computer that is using a NIC whose MAC address is on its “allows” list.
Wi-Fi IAD’s and access points that support MAC filtering let you specify a list of MAC
addresses that may connect to the access point, and thus dictate what devices are
authorized to access the wireless network. When a device is using MAC filtering,
any address not explicitly defined will be denied access.
MAC Restrict mode:
Off - disables MAC filtering; Allow – permits access for the
specified MAC address; deny; reject access of the specified MAC address, then click
the
SET button.
To delete an entry
, select the entry at the bottom of the screen and then click the
Remove button, located on the right hand side of the screen.
To add a MAC entry, click Add and enter MAC address
After choosing the Add button, the following screen appears. Enter the MAC
address and click
Apply to add the MAC address to the wireless MAC address filters.
90