Comtel CT-2100, Instruction Manual

Page: 29 / 32

29
ANTENNA
The antenna is fixed and cannot be pulled out. Always place the unit to an up-right
position for better intercommunication.
LANYARD/STRAP HOLE
You can attach a strap or lanyard so that the unit can be safely and conveniently
carried with you at all times.
RESET BUTTON
Use the reset button only when the device is down / has no response at all. Use a
pointing tool to gently press the reset button inside the small hole on the back
casing. The reset button will return you to the starting point of the device.
NOTES OF USING THE RECHARGEABLE BATTERIES
This baby monitor only recharges the safety-enhanced type of 1.2V AAA
rechargeable battery. It will not recharge any alkaline batteries or even ordinary
rechargeable batteries. Thus you need not to worry about any short-circuit or
damage caused by connecting the main power to the unit with the alkaline
batteries inside.
Please contact an authorized dealer or approved service center if spare is
required.
DIP SWITCH CODE SETTING
The DIP SWITCH which includes 8 combinations can help to avoid interference
from
1. Turn off both TRANSMITTER and RECEIVER and place both units side by
side.
2. Open the battery compartment cover and remove all the batteries.
3. Use a ball pen or any pointing tool to move the switches up or down to set a
new combined code. Make sure the switches up/down pattern on both
TRANSAMITTER and RECEIVER are IDENTICAL.
4. Upon completion, power on both units and make some noise to test.
5. If noise from TRANSMITTER can be heard through RECEIVER, the code of
both units is matched. If not, please check the code pattern on both units.